The touch screen we use in the course - Part 1

The touch screen we use in the course - Part 2

The development board we use int eh course - Part 1

The TTL to USB module we use in the course - Part 1

The development board we use int eh course - Part 2

The TTL to USB module we use in the course - Part 2

The Nextion IO adaptor we use in the course - Part 1

The Nextion IO adaptor we use in the course - Part 2

Downloading and installing Nextion Editor

Bezel for the screen

Explaning Nextion Editor interface - Part 1

Explaning Nextion Editor interface - Part 2

Explaning Nextion Editor interface - Part 3

Changing attributes of a text box with a touch

Adding and using fonts

Scrolling text box

Number box

Using buttons

Using Dual State buttons and Timers

Receiving data on the screen

A bit more about the NExtion Editor interface

Sending data from the screen

Introduction to the course

Course plan

GPIOs of the Screen

GPIOs as Output - Diagram and configurations

Testing the LED project

GPIO as Pulse Width Modulation PWM

Controling an LED from screen - Setting up the project in Nextion Editor

GPIOs as input

Implementing the project in Nextion Editor - Part 2

Implementing the project in Nextion Editor - Part 1

Testing the Project - GPIO as PWM

Creating an animated guage - plan and graphics

Creating the animated guage - Part 1

Creating the animated guage - Part 2

Creating the animated guage - Part 3

Testing the project

Project oerview

Project layout and plan

Creating Page 3 in Nextion Editor

Creating Page 1 in Nextion Editor

Sending the project to the screen

Creating Page 2 in Nextion Editor

Explaining what to change on screen when we read the battery value

Explaining the change and the code plan

Code plan - Part 2

Code plan - Part 1

Code plan - Part 3

Code plan - Part 4

Setting up the project in CubeIDE - Part 1

Setting up the project in CubeIDE - Part 2

ADC reading table

Solving and understanding ADC reading

ADC reading from the battery and the battery ranges

Connecting UART 6 on the Nucleo board

Implementing the function in the code

Including the battery reading in the code

Final code debugging and testing

Introduction to the project

The hardware used in the project

Debugging the project in Nextion Editor

Seeting the project in CubeIDE and solving the assignement

Explaining the project in Nextion Editor

Understanding the system and the code plan for the project

Explaning the MIDI instructions on the code

Testing the project

Testing the project with a logic analyzer